2FastMoto products are moving to Motomentum.com. Register on the new site and save $5 on your first order! Copy the Part Number below and then paste it into the SEARCH box on Motomentum. Click HERE!

2FastMoto Heated Grip Insert Kit ATV Cold Weather Trail Offroad Riding Suzuki
2FastMoto Heated Grip Insert Kit ATV Cold Weather Trail Offroad Riding Suzuki

2FastMoto Heated Grip Insert Kit ATV Cold Weather Trail Offroad Riding Suzuki

Your Price:$26.82
Part Moved to Motomentum.com (see note above)
FREE SHIPPING
Part Number:FHHGUN001

Genuine 2FastMoto Heated Grip Inserts

Works with any Motorcycle, ATV, Dirtbike, or Snowmobile Grip - 7/8" or 1" handlebars

Includes 2 Heating Elements, Switch, Necessary Wiring and Heat Resistant Covers

FEATURES:

Allows use of any desired grip design

Warms up to steady heat when engine is running

Easy installation - Just remove grips, install the insert inside of grips and reinstall grips

Approximate Length: 3 1/2" (works with grips from 4"-5 1/2" long)

Draws approximately 10 watts

Instructions

1) Remove grips.  If you have rubber grips, heat them until they become flexible.  Break the mastic by inserting a phillips screwdriver between the grip and handlebar, then pry grip straight off.  Do not attempt to twist off grip

2) Remove all residues (glue, rubber, etc) from the area covered by grip on handlebar.  Clean properly using either fine sandpaper or gasoline to obtain a residue free surface, ready to receive the heating element.

3) Remove white contact protector from heating element.  Encircle cleaned area with heating element, replace rubber grip on each side.  Attach wires along control wire

4) Mount switch to handlebar.

5) Take the wire from the heating element which is not connected to the switch and attach it to a suitable gorund.

ELECTRIC START MODELS

Take a length of 18 gauge stranded wire and connect it to the end of the single wire which extends from the “Y” junction and connect it to the accessory lug on the rear of the ignition switch

MANUAL START MODELS

The wire mentioned in 5a must be connected to magneto (yellow wire)(+)

6) Turn on switch to heat grips

Brand: 2FastMoto. | Manufacturer Part Number: 2FM-FHGUN001. | Compatible Handlebar Diameter: 7/8" and 1". | Voltage: 12 volt. | Quantity: 1 kit. | Kit Includes: Everything Pictured. |

Related Items

Recently Viewed Items